0/12V or 0/5V VOLTAGE CONTROLLED 2-WAY Switch
| Power passing, 0/5v OR 0/12V switch |
| Use it to connect 2 separate LNBs (on 1 or 2 dishes) that lead into one receiver. |
| Can be used with most MPEG FTA DVB receivers with 0/12V output control. |
| FREQUENCY: 900-2150 MHz |
| LOSS (dB): 3 |
| ISOLATION (dB): 20 |
| RETURN LOSS (dB): 10 |
| OPERATION VOLTAGE: nominally 12 VDC (but works down to 5 VDC) |
| GROUND CONNECTION: negative CONNECTIONS Connect GND to the chassis (ground) of your receiver. Connect 0/12V to your receiver 12V switching output or to your switched voltage source. Connect RX to your receiver LNB input. Connect LNBF-A and LNBF-B to your two LNBs. LNBF-A is normally selected. When you apply the DC voltage, LNBF-B will be selected. |

©2010-2011 SatCure
Send this page address - CLICK HERE - to a friend ! Send this page address - CLICK HERE - to a friend !